RetestPC

Frame Skipping Test

Press Start test and take a photo of the boxes with a slow shutter, about 1/8 second at 144 Hz. The lit boxes should form one solid run. Dark gaps inside the run mean the monitor skips frames.

Any monitor, including overclocked panelsAny camera or phone with a manual shutter
Boxes
12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152535455565758596061626364
Press Start test, then photograph the boxes with a slow shutter.
Refresh rate
--Hz
Frames your browser draws
Shutter to use
--
Lights about 15 to 25 boxes
Dropped frames
0
Missed by the browser
Frame time
--ms
Average time per frame
Press Start test. Close other tabs and keep the mouse still while it runs.
Good: one solid run
Skipping: dark gaps in the run
Doubled: some boxes brighter
Everything runs in your browser. No camera access is needed: use any camera or phone to take the photo.

This frame skipping test lights one box per frame, in order, across a grid of 32 or 64 boxes. A photo taken with a slow shutter captures many frames at once. If the monitor shows every frame, the lit boxes form one unbroken run. If it skips frames, the run has dark gaps.

It is the standard way to check an overclocked monitor, and a quick check for any high refresh rate screen. The test also measures the refresh rate your browser is running at, counts frames the browser itself misses, and tells you which shutter speed to use.

How to run the frame skipping test

  1. Set your monitor to the refresh rate you want to check, and close other tabs and apps.
  2. Press Start test, or Full screen for a bigger grid.
  3. Wait a few seconds until Refresh rate shows your rate and Dropped frames stays at 0.
  4. Set your camera or phone to the shutter speed shown in Shutter to use. On a phone, use Pro or Manual mode.
  5. Hold the camera still, or rest it on the desk, and take a photo of the grid.
  6. Look at the lit boxes in the photo and compare them with the three examples under the test.

Keep the mouse still while you take the photo. Moving it can make the browser miss a frame, which looks like a skip in the photo.

Reading the photo

What you see What it means
One solid run of lit boxes No frame skipping. Every frame reached the screen
Dark boxes inside the run Skipped frames. The monitor dropped them
A regular pattern of gaps, such as every fifth box The monitor runs at a lower rate inside, often 60 Hz, while accepting a higher one
Some boxes brighter than others Those frames stayed on screen twice as long, often from a frame the browser drew late
Two separate runs The run wrapped around the grid. Use a faster shutter

The lit run starts and ends at random boxes, depending on when you pressed the shutter. That is normal.

What the readouts mean

Readout What it shows
Refresh rate The rate your browser draws at, from the time between frames
Shutter to use A common shutter speed that lights about 15 to 25 boxes
Dropped frames Frames the browser missed since you pressed Start
Frame time Average time per frame, 6.94 ms at 144 Hz

If the refresh rate reads lower than your setting, the monitor is not running at that rate at all. The refresh rate test explains how to set it in Windows and on a Mac.

Frame skipping on an overclocked monitor

Overclocking means setting a refresh rate above the rated one with a custom resolution, for example in the NVIDIA Control Panel, AMD Software or a custom resolution tool. Many monitors accept the higher rate but cannot run their panel that fast, so they skip frames to keep up.

If the photo shows gaps:

  1. Lower the custom refresh rate by 2 to 5 Hz and test again.
  2. Try reduced blanking timings in the custom resolution, which lower the bandwidth needed.
  3. Use DisplayPort or a newer HDMI cable, since a link at its limit can also cause problems.
  4. If it still skips, go back to the rated refresh rate. A skipping 75 Hz looks worse than a clean 60 Hz.

Frame skipping at the rated refresh rate

A monitor at its stock rate should not skip. If it does:

  • Turn off any motion smoothing, black frame insertion or "overdrive extreme" modes and test again.
  • Update the monitor's firmware if the maker offers one.
  • Check that the cable is rated for the refresh rate and resolution.
  • If it continues, it is a fault worth reporting to the maker under warranty.

Other motion tests

Skipped frames look like uneven motion. The ufo test shows motion smoothness at your full refresh rate, and the 144hz monitor test compares 144 Hz with lower rates side by side. Tearing lines across the screen are a different issue, checked by the screen tearing test.

Limits of a browser frame skipping test

The browser can only report whether it drew each frame, not whether the monitor showed it. The photo is what proves frame skipping. Variable refresh rate, G-Sync and FreeSync can also change the timing in a browser, so for the cleanest result test with them off.

Phones that only offer automatic shutter speeds may not go slow enough. A slow motion video, played back frame by frame, works as an alternative: each box should light in turn with none missing.

Frame skipping questions

What is monitor frame skipping?

Frame skipping is when a monitor accepts a refresh rate but does not show every frame. It reports 75 or 144 Hz to the computer while quietly dropping some frames, so motion looks less smooth than the rate suggests. It happens most often on overclocked monitors.

How do I check for frame skipping?

Run this test and take a photo with a shutter speed long enough to catch 15 to 25 frames, which the test suggests for your refresh rate. Each frame lights one box. If every box in the lit run is lit, no frames were skipped. Dark boxes inside the run are skipped frames.

Can I do a frame skipping check without a camera?

Not reliably. The browser can tell you whether it drew every frame, which this test reports as dropped frames, but only a camera sees what the monitor actually showed. A phone's slow motion video also works: each box should light in turn with none missed.

Why does the test show dropped frames?

Dropped frames here are frames your browser missed, not the monitor. They come from a busy computer, other tabs, a laptop on battery saver or moving the mouse. Close other apps and keep the mouse still, then take the photo.

Does frame skipping happen at the stock refresh rate?

Rarely. A monitor running at its rated refresh rate, such as 144 Hz on a 144 Hz monitor, should show every frame. Frame skipping is almost always caused by overclocking the refresh rate with a custom resolution.

What shutter speed should I use?

Long enough to light 15 to 25 boxes: about 1/4 second at 60 Hz, 1/8 second at 144 Hz and 1/15 second at 240 Hz. The test suggests the closest common shutter speed for the refresh rate it measures.